Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P157A

DTC P16D7, P16D8, P16D9 = Not set
KR200 Engine Controls Sensor Supply Voltage Relay = The component is commanded Off

Frequency the DTC runs = Continuously - After the running conditions are met

P16D7, P16D8

Ignition and Start Signal = Greater than 11 V
KR200 Engine Controls Sensor Supply Voltage Relay = The component is commanded Off

Frequency the DTC runs = Continuously - After the running conditions are met

P16D9

Ignition and Start Signal = Greater than 11 V
KR200 Engine Controls Sensor Supply Voltage Relay = The component is commanded On

Frequency the DTC runs = Continuously - After the running conditions are met