Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P208A, P208C, P208D, P214E
- DTC P10F4, P20FF, U010E = Not set
- Ignition = On or Engine = Running
- Ignition and Start Switch Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P149F, P208B, P2C11
- DTC P10C9, P10CA, P10DA, P10DB, P14FA, P20FF, U010E, U2412, U2626 = Not set
- DTCs related to the following system/component = Not Set B194 Reductant Pressure Sensor
- No other DTCs related to the concerned component are set.
- Ignition = On or Engine = Running
- Ignition and Start Switch Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 63 s