Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On / Vehicle - In Service Mode
Verify there are no DTCs set related to the following component/system:
- B17 Barometric Pressure Sensor
- B34 Engine Coolant Temperature Sensor
- B66 Intake Air Temperature Sensor
- B74 Manifold Absolute Pressure Sensor
- B75C Multifunction Intake Air Sensor
- B115 Vehicle Speed Sensor
- B130 Exhaust Gas Recirculation Temperature Sensor
- B131 Exhaust Temperature Sensor
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- If a related DTC is set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If a related DTC is not set
Verify the condition does not exist:
- Air Cleaner Element - Saturated with water/Restricted
- Exhaust System - Leaking/Missing components/Restricted - Refer to: Symptoms - Engine Exhaust
- Induction System - Leaking/Restricted
- Q20 Intake Air Flow Valve - Binding or Sticking/Restricted
- If a condition exists
  Repair or replace as necessary
- Go to next step: If no condition exists
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Replace the component: Q14A Exhaust Gas Recirculation Valve 1
- Go to next step: If the DTC does not set
All OK.