Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify there are no DTCs set related to the following component/system: B34 Engine Coolant Temperature Sensor
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Verify the following conditions do not exist:
- Exhaust Gas Recirculation Valve Cooler - Restricted
- Exhaust Gas Recirculation Valve 2 - Binding or Sticking/Restricted/Visible Damage
- Exhaust Pressure Control Valve - Binding or Sticking/Restricted
- Exhaust Gas Recirculation System - Leaking/Restricted
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- Clear the DTCs.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Replace the component: M122 Exhaust Pressure Regulator Valve
- Go to next step: If no DTC is set
- If the DTC sets
- All OK.