Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P118A, P11C9, P1387
- DTC P117A, U111A = Not set
- DTCs related to the following system/component = Not Set
- KR75 Engine Controls Ignition Relay
- {P118A} Engine Block Coolant Control Valve Position = Less than -7°
- {P11C9} Engine Block Coolant Control Valve Position = Greater than 117°
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P26C0, P26C2
- DTC P117A, U111A = Not set
- DTCs related to the following system/component = Not Set
- KR75 Engine Controls Ignition Relay
- {P26C0} DTC P118A = Not set
- Engine Block Coolant Control Valve Position = -5 to 115°
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
U111A, U1379
- Ignition = On
- Ignition Voltage = Greater than 11 V
- Power Mode = Run
Frequency the DTC runs = Continuously - After the running conditions are met