LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (4 Of 5)) >> Diagnostic Information and Procedures >> DTC P10F3, P20BD-P20BF, P20C0, P221C, or P221D >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: E52 Reductant Line Heater
  3. Test for 1 to 6 ohms between the test points: Control terminal 1 & Control terminal 2
    • If not between 1 and 6 ohms 

      Replace the component: E52 Reductant Line Heater

    • Go to next step: If between 1 and 6 ohms 
  4. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: E52 Reductant Line Heater

    • Go to next step: If infinite resistance 
  5. All OK.