Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P10C1, P10EC, P10ED, P2010
- Engine Cranking
- Ignition and Start Switch Signal = On
- Ignition and Start Signal = Greater than 11 V
- Intake Manifold Runner Control Valve Command = Greater than 0%
Frequency the DTC runs = Continuously - After the running conditions are met
P2008, P201B
- Engine Cranking
- Ignition and Start Switch Signal = On
- Ignition and Start Signal = Greater than 11 V
- Intake Manifold Runner Control Valve Command = 0%
Frequency the DTC runs = Continuously - After the running conditions are met