Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0685, P0686, P0687
- Ignition and Start Signal = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0689
- Engine Controls Ignition Supply Voltage Command = On
- Ignition and Start Signal = Greater than 9 V
Frequency the DTC runs = Continuously - After the running conditions are met
P0690
- DTC P0685, P0686, P0687 = Not set
- Engine Controls Ignition Supply Voltage Command = Off - For greater than 2 s
Frequency the DTC runs = Continuously - After the running conditions are met
P1682, P16BC
- Engine Controls Ignition Supply Voltage Command = On
- Ignition and Start Signal = Greater than 5.5 V
Frequency the DTC runs = Continuously - After the running conditions are met
P16BD
- Engine Controls Ignition Supply Voltage = Greater than 11 V
- Engine Controls Ignition Supply Voltage Command = On
- Ignition and Start Signal = Greater than 9 V
Frequency the DTC runs = Continuously - After the running conditions are met
P16BF
- Engine Controls Ignition Supply Voltage = Inactive
Frequency the DTC runs = Continuously - After the running conditions are met