LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (3 Of 5)) >> Diagnostic Information and Procedures >> DTC P0685-P0687, P0689, P0690, P1682, P16BC, P16BD, or P16BF >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.
Circuit* Description
B+ - Relay Coil Supplied directly from the battery.
B+ - Relay Switch Supplied directly from the battery.
Control - Component The output circuit is switched to 12 V to activate the component.
Control - Relay Coil The output circuit is switched to ground to activate the component.
*For detailed component terminal information, refer to: Diagnostic Aids
Component Description
K20 Engine Control Module The control module contains a microprocessor used to process input data to control outputs.
The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.
KR75 Engine Controls Ignition Relay Relays are used to control a high power circuit with a low power signal.

There are 2 ignition voltage circuits supplied to the ECM. The 2 circuits are supplied by 2 relay (s): KR73 Ignition Main Relay & KR75 Engine Controls Ignition Relay

The ECM monitors and compares the voltages supplied by the relay (s).

scientia non olet · About LEMON Manuals