Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P0628

DTC U18A2 = Not set
Engine Speed = Greater than 0 RPM
Ignition and Start Signal = Greater than 11 V
Fuel Pump Control Circuit = On

Frequency the DTC runs = Continuously - After the running conditions are met

P0629

DTC U18A2 = Not set
Engine = Cranking Greater than 0 RPM
Ignition and Start Signal = Greater than 11 V
Fuel Pump Control Circuit = Off

Frequency the DTC runs = Continuously - After the running conditions are met

P12A6

DTC P11FF, U18A2 = Not set
Engine Speed = Cranking/Running - For less than 1 s
Ignition and Start Signal = Greater than 11 V

Frequency the DTC runs = Continuously - After the running conditions are met