Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Attach the mechanics wire to the new hood primary latch release cable (2) and guide the cable in.
Connect the hood primary latch release cable grommet (1) to the plenum upper panel.
Courtesy of GENERAL MOTORS COMPANY

Install the hood primary latch release cable end retainer (1) to the inside handle (2).
Courtesy of GENERAL MOTORS COMPANY

Install the hood primary latch release cable handle retainers (1) to the instrument panel lower trim panel outer filler.
Courtesy of GENERAL MOTORS COMPANY

Attach the hood primary latch release cable (1) to the retainers (2).
Courtesy of GENERAL MOTORS COMPANY

Attach the hood primary latch release cable to the retainer (2).
Connect the hood primary latch release cable end retainer (1) to the latch.
Courtesy of GENERAL MOTORS COMPANY

Intake Air Splash Shield (2) - Install
Intake Air Baffle Retainer (1) - Install [9x]
Courtesy of GENERAL MOTORS COMPANY

Hood Secondary Latch Release Handle (2) - Install

CAUTION:

Hood Latch Actuator Bolt (1) - Install and tighten [2x] - Fastener Specifications