Installation Procedure
Install the instrument panel upper trim panel (1) with the aid of an assistant.
- Connect the electrical connector.
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Airbag Bolt (1) - Install and tighten [3x] - Fastener Specifications
Instrument Panel Cluster Trim Plate (2) - Install
- Instrument Panel Cluster Trim Plate Bolt (1) - Tighten [4x] - Fastener Specifications
Connect the electrical connectors.
- Instrument Panel Transmission Shift Opening Cover (2) - Install
- Instrument Panel Center Trim Panel Bolt (1) - Install and tighten [6x] - Fastener Specifications
Instrument Panel Upper Trim Panel Bolt (1) - Install and tighten [15x] - Fastener Specifications
Connect the electrical connector.
- Radio Front Speaker (2) - Install
- Radio Front Speaker Bolt (1) - Install and tighten [2x] - Fastener Specifications
Radio Front Speaker Grille (1) - Install
Windshield Garnish Molding (3) - Install
- Windshield Pillar Assist Handle Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Windshield Pillar Assist Handle Cover (1) - Install [2x]
- Reposition the weatherstrip as necessary.
Connect the electrical connector.
- Instrument Panel Trim Pad (2) - Install
- Instrument Panel Upper Trim Panel Bolt (1) - Install and tighten [6x] - Fastener Specifications
Instrument Panel Center Trim Plate Applique (1) - Install
Instrument Panel Trim Plate Applique (1) - Install
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Connect the electrical connector.
- Radio Front Center Speaker (2) - Install
- Radio Front Center Speaker Bolt (1) - Install and tighten [2x] - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Extension (1) - Install
Connect the electrical connector.
- Radio Front Speaker (2) - Install
- Radio Front Speaker Bolt (1) - Install and tighten [2x] - Fastener Specifications
Radio Front Speaker Grille (1) - Install
Windshield Garnish Molding Bolt (2) - Install and tighten - Fastener Specifications
- Align the retaining clips with the slots in the A pillar and press the windshield garnish molding (1) into place.
- Windshield Garnish Molding (1) - Install
- Reposition the weatherstrip as necessary.
Connect the electrical connectors.
- Instrument Panel Switch Trim Plate (2) - Install
- Instrument Panel Switch Trim Plate Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connectors.
- Instrument Panel Trim Pad (2) - Install
- Instrument Panel Trim Pad Bolt (1) - Install and tighten [2x] - Fastener Specifications
Instrument Panel Trim Plate Applique (1) - Install
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Instrument Panel Lower Trim Panel Outer Filler (1) - Install
- Enable the SIR System. SIR Disabling and Enabling