Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Lower Applique (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Applique (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Trim Plate Applique (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Center Trim Plate Applique (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Upper Trim Panel Bolt (1) - Remove [6x]
Using a flat-bladed plastic trim tool, release the retaining clips.
Disconnect the electrical connector.

NOTE:

Use care not to bend or deform the thin area of the instrument panel trim pad.

Instrument Panel Trim Pad (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment Bolt (1) - Remove [2x]
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Lower Trim Panel Outer Filler (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Lower Center Trim Plate Applique (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Lower Trim Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment Bolt (1) - Remove [10x]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment (1) - Remove