Removal Procedure
- Front Wheelhouse Liner - Right Side - Remove - Front Wheelhouse Liner Replacement
Catalytic Converter Brace Bracket Nut (1) - Remove [2x]
- Wiring Harness Retainer (2) - Remove
- Raise the vehicle.
Using a suitable tool, remove the position 2 nitrogen oxides sensor (1) from the nitrogen oxides catalytic converter.
Using a suitable tool, remove the position 3 nitrogen oxides sensor (1) from the nitrogen oxides catalytic converter.
Using a suitable tool, remove the exhaust particulate sensor (1) from the nitrogen oxides catalytic converter.
Exhaust Pipe Clamp (1) - Loosen
Exhaust Front Pipe Nut (1) - Remove [2x]
Catalytic Converter Brace Bracket (1) - Remove
Exhaust Front Pipe Nut (1) - Remove [2x]
Nitrogen Oxides Catalytic Converter (1) - Remove
- Exhaust System Front Gasket (2) - Remove and DISCARD
- Support the transmission with a suitable jack.
Remove the wiring harness (2) from the 3 retainers (1) and reposition as necessary.
Transmission Mount Nut (1) - Remove
- Transmission Support Crossmember Nut (2) - Remove [4x]
- Transmission Support Crossmember Bolt (3) - Remove [4x]
Transmission Support Crossmember (1) - Remove
- Lower the transmission enough to gain access to the transmission vent hose.
Remove the 2 transmission vent hose retainers (1).
- Remove the transmission vent hose. (2)