Removal Procedure
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Transfer Case Skid Shield Bolt (1) - Remove [3x]
- Transfer Case Skid Shield (2) - Remove
- Support the transmission with a suitable jack.
Remove the wiring harness (2) with automatic level control air supply line (3) from the retainers (1) and reposition as necessary.
Remove the chassis wire harness clip (1) from the automatic level control air supply reservoir.
Remove the 3 automatic level control air compressor bolts (1).
- Reposition and support the automatic level control air supply reservoir (2) out of the way of the transmission support crossmember.
Transmission Mount Nut (1) - Remove [2x]
- Transmission Support Crossmember Nut (2) - Remove [4x]
- Transmission Support Crossmember Bolt (3) - Remove [4x]
Transmission Support Crossmember (1) - Remove
- Lower the transmission enough to gain access to the transmission vent hose clip bracket.
Remove the engine wiring harness retainer (1) and reposition the engine wiring harness (2) as necessary.
Remove the transfer case vent hose retainer (1).
- Transfer Case Vent Hose (2) - Remove
Remove the transmission vent hose retainer (1) then reposition the transmission vent hose (2) as necessary.
Remove the transmission vent hose clip bracket nut (1).
- Remove the transmission vent hose clip bracket (2).