LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 10L80 (MHS MQC) - Repair Instructions - On Vehicle (1 Of 2) >> Repair Instructions - On Vehicle >> Transmission Vent Hose Clip Bracket Replacement (L84, L87, 2WD and F47) >> Installation Procedure

Installation Procedure

  1. GM5600854Courtesy of GENERAL MOTORS COMPANY

    Install the transmission vent hose clip bracket (2).

    2. CAUTION:

    Refer to Fastener Caution

  2. Install and tighten the transmission vent hose clip bracket nut (1). Fastener Specifications
  3. GM5600801Courtesy of GENERAL MOTORS COMPANY

    Reposition the transmission vent hose (2) then install the transmission vent hose retainer (1).

  4. GM5600725Courtesy of GENERAL MOTORS COMPANY

    Reposition the engine wiring harness (2) then install the engine wiring harness retainer (1).

  5. Raise the transmission into place.
  6. GM5587449Courtesy of GENERAL MOTORS COMPANY

    Transmission Support Crossmember (1) - Install

  7. GM5587388Courtesy of GENERAL MOTORS COMPANY

    Transmission Support Crossmember Bolt (3) - Install [4x]

  8. Transmission Support Crossmember Nut (2) - Install and tighten [4x] - Fastener Specifications
  9. Transmission Mount Nut (1) - Install and tighten - Fastener Specifications
  10. Remove the transmission jack.
  11. GM5611961Courtesy of GENERAL MOTORS COMPANY

    Automatic Level Control Air Supply Reservoir (2) - Install

  12. Install the 3 automatic level control air compressor bolts (1) and tighten. Fastener Specifications
  13. GM5611960Courtesy of GENERAL MOTORS COMPANY

    Install the chassis wire harness clip (1) to the automatic level control air supply reservoir.

  14. GM5624947Courtesy of GENERAL MOTORS COMPANY

    Install the wiring harness (2) with automatic level control air supply line (3) into the retainers (1).

  15. Lower the vehicle.
scientia non olet · About LEMON Manuals