Conditions for Running the DTC

P0721, P172A, P172B

• { P077C, P077D } Engine Speed = Greater than 499 RPM
• Battery Voltage = Greater than 9 V
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• { P077C, P077D } Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running Conditions are met

P0722, P0723

• { P0722 } DTC P0723, P077C, P077D = Not set
• DTCs related to the following system/component = Not Set
  • B14A Automatic Transmission Output Speed Sensor
  • B74 Manifold Absolute Pressure Sensor
  • B75 Mass Airflow Sensor
  • B107 Accelerator Pedal Position Sensor
  • Q14 Exhaust Gas Recirculation Valve
  • Q17 Fuel Injector
  • Engine Misfire
  • Fuel Trim System
• { P0722 } Accelerator Pedal Position Sensor = Greater than 3%
• Battery Voltage = Greater than 9 V
• { P0722 } Engine Torque = Greater than 30 Nm (22 lb ft)
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On

Frequency the DTC runs = Continuously - After the running Conditions are met

P077C, P077D

• { P077C } DTC P077D = Not set
• { P077D } DTC P077C = Not set
• Battery Voltage = Greater than 10 V
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running Conditions are met