Conditions for Running the DTC

P0711 Condition 1

• DTC P0712, P0713, P2818 = Not set
• DTCs related to the following system/component = Not Set
  • B14A Automatic Transmission Output Speed Sensor
  • B26 Crankshaft Position Sensor
  • B34 Engine Coolant Temperature Sensor
  • B74 Manifold Absolute Pressure Sensor
  • B75 Mass Airflow Sensor
  • B107 Accelerator Pedal Position Sensor
  • Q17 Fuel Injector
  • Engine Misfire
  • Fuel Trim System
• Accelerator Pedal Position Sensor = Greater than 4%
• Battery Voltage = Greater than 9 V
• Engine Coolant Temperature = -40 to 150°C (-40 to 302°F)
• Engine Speed = Greater than 500 RPM
• Engine Torque = Greater than 50 Nm (37 lb ft)
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Transmission Fluid Temperature = -40 to 150°C (-40 to 302°F)
• Vehicle Speed = Greater than 10 km/h (7 MPH)

Frequency the DTC runs = Continuously - After the running Conditions are met

P0711 Condition 2, 3 & P0712, P0713

• Battery Voltage = Greater than 9 V
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• {P0711 Condition 3} Transmission Fluid Temperature = -40 to 150°C (-40 to 302°F)

Frequency the DTC runs = Continuously - After the running Conditions are met