Circuit/System Verification
- Engine - Running
- Verify the scan tool parameter:
- High Side Driver Circuit High Test Status = Not Run or Okay
- High Side Driver Circuit Low Test Status = Not Run or Okay
- High Side Driver Circuit Open Test Status = Not Run or Okay
- Transmission Control Solenoid Valve 7, 8 Control Circuit High Test Status = Not Run or Okay
- Transmission Control Solenoid Valve 7, 8 Control Circuit Low Test Status = Not Run or Okay
- Transmission Control Solenoid Valve 7, 8 Control Circuit Open Test Status = Not Run or Okay
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the Conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.