LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (1 Of 2)) >> Repair Instructions >> Charge Air Temperature Secondary Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Oil Filler Cap - Remove
  2. GM5171779Courtesy of GENERAL MOTORS COMPANY

    Intake Manifold Cover Bolt (1) - Remove

  3. Intake Manifold Cover (2) - Remove
  4. Install the oil filler cap after removal of the intake manifold cover to prevent debris from falling into the engine.
  5. GM5146541Courtesy of GENERAL MOTORS COMPANY

    Disconnect the charge air temperature secondary sensor electrical connector.

  6. Charge Air Temperature Secondary Sensor (1) - Remove
scientia non olet · About LEMON Manuals