Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Turbocharger Heat Shield Bolt (1) - Remove [2x]
Turbocharger Heat Shield Nut (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Heat Shield (1) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Remove the 3 rear engine wiring harness channel nuts (1).
Position the rear engine wiring harness channel (2) out of the way.
Courtesy of GENERAL MOTORS COMPANY

Using an appropriate tool, remove and DISCARD the turbocharger wastegate actuator arm retainers (1)
Variable Geometry Turbocharger Actuator Lever (2) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

Disconnect the variable geometry turbocharger actuator electrical connector.
Turbocharger Wastegate Actuator Bolt (1) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

Variable Geometry Turbocharger Actuator (1) - Remove and DISCARD