Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Oil Filler Cap - Remove
Intake Manifold Cover Bolt (1) - Remove
- Intake Manifold Cover (2) - Remove
- Install the oil filler cap after removal of the intake manifold cover to prevent debris from falling into the engine.
- Disconnect the nitrogen oxide sensor electrical wiring harness connector.
Nitrogen Oxides Sensor Nut (1) - Remove [2x]
- Nitrogen Oxides Sensor (2) - Position aside
Upper Intake Manifold Brace Nut (1) - Remove [3x]
- Upper Intake Manifold Bracket (2) - Remove
Charge Air Cooler Inlet Air Hose Clamp (1) - Loosen until disengaged [2x]
- Charge Air Cooler Inlet Air Hose (2) - Remove
Release the retainer spring (1).
- Intake Manifold Resonator (2) - Remove