Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Hood Latch Actuator Bolt (1) - Remove [2x]
- Hood Secondary Latch Release Handle (2) - Remove
Intake Air Baffle Retainer (1) - Remove [9x]
- Intake Air Splash Shield (2) - Remove
Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [2x]
- Front End Sheet Metal Diagonal Brace (2) - Remove
- NOTE:
- Some components not shown for graphic clarity.
- Right side shown, left side similar.
Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [2x]
- Front End Sheet Metal Diagonal Brace (2) - Remove
Intake Air Duct Retainer (1) - Remove
- Intake Air Duct (2) - Remove