LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (2 Of 2)) >> Repair Instructions >> Exhaust Pressure Sensor Pipe Replacement - Nitrogen Oxides Catalytic Converter >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5571687Courtesy of GENERAL MOTORS COMPANY

    Plenum Front Panel Outer Reinforcement (1) - Remove - Plenum Front Panel Outer Reinforcement Removal and Installation

  2. GM5156146Courtesy of GENERAL MOTORS COMPANY

    Disconnect the exhaust pressure differential sensor electrical connector (1).

  3. Remove the wiring harness retainer from the stud.
  4. Exhaust Pressure Differential Sensor Bracket Nut (2) @ Exhaust Pressure Differential Sensor - Remove
  5. GM5156615Courtesy of GENERAL MOTORS COMPANY

    Exhaust Pressure Sensor Hose Clamp (1) - Disengage [2x] - Hose Clamp Replacement Guidelines - Spring Type

  6. GM5387805Courtesy of GENERAL MOTORS COMPANY

    Exhaust Pressure Sensor Pipe (1) - Remove

scientia non olet · About LEMON Manuals