LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (2 Of 2)) >> Repair Instructions >> Exhaust Pressure Differential Sensor Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5571687Courtesy of GENERAL MOTORS COMPANY

    Plenum Front Panel Outer Reinforcement (1) - Remove - Plenum Front Panel Outer Reinforcement Removal and Installation

  2. GM5170071Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness Bracket Nut (1) - Remove [3x]

  3. Engine Wiring Harness Channel (2) Reposition
  4. GM5155399Courtesy of GENERAL MOTORS COMPANY

    Disengage the engine wiring harness retainer and temperature sensor retainers and clips from top of sensor bracket.

  5. Exhaust Pressure Differential Sensor Bracket Nut (1) - Remove
  6. Exhaust Pressure Differential Sensor - Reposition
  7. GM5156146Courtesy of GENERAL MOTORS COMPANY

    Disconnect the exhaust pressure differential sensor electrical connector (1).

  8. Remove the wiring harness retainer from the stud.
  9. Exhaust Pressure Differential Sensor Bracket Nut (2) @ Exhaust Pressure Differential Sensor - Remove
  10. GM5170128Courtesy of GENERAL MOTORS COMPANY

    Exhaust Pressure Differential Sensor Bracket Stud (1) - Remove [2x]

  11. Exhaust Pressure Differential Sensor Bracket (2) - Remove
scientia non olet · About LEMON Manuals