LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (2 Of 2)) >> Repair Instructions >> Exhaust Pressure Differential Sensor Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5170128Courtesy of GENERAL MOTORS COMPANY

    Exhaust Pressure Differential Sensor Bracket (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Exhaust Pressure Differential Sensor Bracket Stud (1) - Install and tighten [2x] - Fastener Specifications
  3. GM5156146Courtesy of GENERAL MOTORS COMPANY

    Exhaust Pressure Differential Sensor Bracket Nut (2) @ Exhaust Pressure Differential Sensor - Install and tighten - Fastener Specifications

  4. Connect the exhaust pressure differential sensor electrical connector (1).
  5. Instal the wiring harness retainer to the stud.
  6. GM5155399Courtesy of GENERAL MOTORS COMPANY

    Exhaust Pressure Differential Sensor - Install

  7. Exhaust Pressure Differential Sensor Bracket Nut (1) - Install and tighten - Fastener Specifications
  8. Attach the engine wiring harness retainer and temperature sensor retainers and clips to the top of sensor bracket.
  9. GM5170071Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness Channel (2) Install

  10. Engine Wiring Harness Bracket Nut (1) - Install and tighten - Fastener Specifications [3x]
  11. GM5571687Courtesy of GENERAL MOTORS COMPANY

    Plenum Front Panel Outer Reinforcement (1) - Install - Plenum Front Panel Outer Reinforcement Removal and Installation

scientia non olet · About LEMON Manuals