Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
Refer to Component Fastener Tightening Caution .
Using a suitable tool, install and tighten the exhaust particulate matter sensor (1). Fastener Specifications
Clip (1) @ Exhaust Particulate Matter Sensor - Engage [2x]
Clip (3) @ Exhaust Particulate Matter Sensor - Engage [2x]
- Nitrogen Oxides Sensor Nut (2) - Install and tighten - Fastener Specifications
- Exhaust Particulate Sensor Bolt (1) - Install and tighten - Fastener Specifications
- Connect the exhaust particulate matter sensor electrical connector
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .