Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Drain the cooling system. Cooling System Draining and Filling (Static LM2) , or Cooling System Draining and Filling (GE 47716 LM2)
Plenum Front Panel Outer Reinforcement (1) - Remove - Plenum Front Panel Outer Reinforcement Removal and Installation
Remove the exhaust gas recirculation valve bracket nut (1) and reposition harness and retainers as needed.
- Remove the heater inlet hose bracket (2) attached to the exhaust gas recirculation valve.
- NOTE:
Only need to remove the 1 nut at the turbocharger stud.
Engine Wiring Harness Bracket Nut (2) - Remove
- Engine Wiring Harness (1) - Reposition
Exhaust Pressure Differential Sensor Bracket Stud (1) - Remove [2x]
- Exhaust Pressure Differential Sensor Bracket (2) - Reposition
Exhaust Pressure Sensor Hose Clamp (1) @ Exhaust Pressure Differential Sensor Pipe - Disengage - Hose Clamp Replacement Guidelines - Spring Type
Exhaust Gas Recirculation Pipe Nut (1) - Remove
- NOTE:
The clamp is part of the pipe and single use.
Exhaust Gas Recirculation Pipe Nut (1) - Remove
Exhaust Gas Recirculation Valve Hose (1) - Remove
- Exhaust Gas Recirculation Outlet Pipe Gasket (2) - Remove and DISCARD
- Exhaust Gas Recirculation Valve Vacuum Hose Clamp (3) - Remove and DISCARD