Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Exhaust Gas Recirculation Cooler Inlet Pipe Gasket - Upper (4) - Install NEW
- Exhaust Gas Recirculation Cooler Inlet Pipe Gasket - Lower (3) - Install NEW
- Exhaust Gas Recirculation Pipe (2) - Install
- Exhaust Gas Recirculation Cooler Inlet Pipe Bolt (1) - Install and tighten [4x] - Fastener Specifications
- Front Wheelhouse Liner-Right Side - Install - Front Wheelhouse Liner Replacement
CAUTION:
Refer to Fastener Caution .