LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (2 Of 2)) >> Repair Instructions >> Emission Reduction Fluid Tank Shield Replacement (Short Wheelbase) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5609653Courtesy of GENERAL MOTORS COMPANY

    Emission Reduction Fluid Tank Shield (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Emission Reduction Fluid Tank Protector Bolt (1) - Install and tighten [4x] - Fastener Specifications
  3. GM5609651Courtesy of GENERAL MOTORS COMPANY

    Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Install

  4. Retainer (3) - Install
  5. Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Connect - Plastic Collar Quick Connect Fitting Service
  6. Electrical Connector (1) - Connect
  7. GM5609650Courtesy of GENERAL MOTORS COMPANY

    Emission Reduction Fluid Tank Protector (2) - Install

  8. Retainer (1) - Install
  9. GM5609635Courtesy of GENERAL MOTORS COMPANY

    Emission Reduction Fluid Tank Heat Shield (1) - Install

  10. GM5609634Courtesy of GENERAL MOTORS COMPANY

    Emission Reduction Fluid Tank Heat Shield Retainer (1) - Install [2x]

  11. GM5609633Courtesy of GENERAL MOTORS COMPANY

    Emission Reduction Fluid Tank Heat Shield Retainer (1) - Install [4x]

  12. Lower the vehicle.
scientia non olet · About LEMON Manuals