Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Outlet Duct Clamp (1) - Loosen [2x]
Air Cleaner Outlet Front Duct (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Latch Actuator Bolt (1) - Remove [2x]
Hood Secondary Latch Release Handle (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Air Baffle Retainer (1) - Remove [9x]
Intake Air Splash Shield (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Air Duct Retainer (1) - Remove
Intake Air Duct (2) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Disconnect the mass airflow sensor electrical connector.
Air Cleaner Housing Cover Bolt (1) - Remove [3x]
Air Cleaner Upper Housing (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Remove all retainers from air cleaner lower housing.
Electrical Connector (1) @ Air Cleaner Lower Housing - Remove
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness Fuse Block Bracket Bolt (1) - Remove
Accessory Wiring Junction Block (2) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Nut (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Lower Housing (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Mass Airflow Sensor Bolt (1) - Remove [2x]
Mass Airflow Sensor (2) - Remove