LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Transfer Case - Mp 3025 (NQH)) >> Repair Instructions - On Vehicle >> Transfer Case Vent Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5607888Courtesy of GENERAL MOTORS COMPANY

    Transfer Case Vent Hose (2) - Install

  2. Install the transfer case vent hose retainer (1).
  3. GM5607884Courtesy of GENERAL MOTORS COMPANY

    Transfer Case Vent Hose (1) - Connect

  4. Raise the transmission and transfer case assembly into place.
  5. GM5587680Courtesy of GENERAL MOTORS COMPANY

    Transmission Support Crossmember (1) - Install

  6. GM5587684Courtesy of GENERAL MOTORS COMPANY

    Transmission Support Crossmember Bolt (3) - Install [4x]

    7. CAUTION:

    Refer to Fastener Caution

  7. Transmission Support Crossmember Nut (2) - Install and tighten [4x] - Fastener Specifications
  8. Transmission Mount Nut (1) - Install and tighten [2x] - Fastener Specifications
  9. GM5590117Courtesy of GENERAL MOTORS COMPANY

    If equipped, position the wiring harness (2) as necessary then install the harness into the 3 wiring harness retainers (1).

  10. Remove the transmission jack.
  11. GM4968633Courtesy of GENERAL MOTORS COMPANY

    {If equipped} Transfer Case Skid Shield (2) - Install - Transfer Case Skid Shield Replacement

  12. Lower the vehicle.
scientia non olet · About LEMON Manuals