LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Transfer Case - Mp 3025 (NQH)) >> Repair Instructions - Off Vehicle >> Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
GM5055905Courtesy of GENERAL MOTORS COMPANY
  1. Ensure the printing on the bearing is facing upward.
  2. A suitable adapter is required to use with the J-8092  Universal Driver to install.
  3. Press the transfer case four wheel drive actuator lever bearing (1) with a suitable adapter and the J-8092  Universal Driver until the transfer case four wheel drive actuator lever bearing (1) bottoms on the rear case half.
scientia non olet · About LEMON Manuals