Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify there are no DTCs set related to the following component/system: K69 Transfer Case Control Module
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Verify the scan tool can communicate with the following component: K69 Transfer Case Control Module
- If the scan tool cannot communicate with the component
Refer to: Symptoms - Data Communications
- Go to next step: If the scan tool can communicate with the component
- If the scan tool cannot communicate with the component
- Verify that no DTCs are set.
- If any DTC is set
- Go to next step: If no DTC is set
- All OK.