Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Clear DTCs
Perform the scan tool control function:
Transfer Case Range - Neutral

Transfer Case Range - 2WD

Transfer Case Range - 4WD/AWD Automatic

Transfer Case Range - 4WD High/Locked

Transfer Case Range - 4WD Low

Verify the scan tool parameter:

Range Actuator Position = Neutral

Range Actuator Position = 2WD

Range Actuator Position = 4WD/AWD Automatic

Range Actuator Position = 4WD High/Locked

Range Actuator Position = 4WD Low
- If not the specified values
  Refer to: Circuit/System Testing
- Go to next step: If the specified values
Verify DTC C11A4 is not set.
- If the DTC is set
  Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
All OK.