Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC C1162 is not set.
- If the DTC is set
Refer to: DTC C1162
- Go to next step: If the DTC is not set
- If the DTC is set
- Verify DTC C116E is not set.
- If the DTC is set
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC is set
- Operate the vehicle within the Conditions for Running the DTC.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.