Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify there are no other DTCs set, except for DTC C05FF and/or C15AC.
- If any other DTCs are set
Diagnose other DTCs first. Refer to: Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no other DTCs are set
- If any other DTCs are set
- Verify DTC C05FF and/or C15AC is not set.
- If the DTC is set
- Perform the following learn procedure: Range Actuator Correlation Learn - Refer to: Transfer Case Range Actuator Correlation Learn
- Clear DTCs.
- Ignition/Vehicle - Off
- Disconnect the data link connector.
- Wait 30 s before proceeding to the next step.
- Ignition - On/Vehicle - In Service Mode
- Verify the procedure was successful.
- If the procedure was successful
All OK.
- Go to next step: If the procedure was not successful
- If the procedure was successful
- Test or replace the component: A16 Transfer Case Four Wheel Drive Actuator
- Go to next step: If the DTC is not set
- All OK.