Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify there are no other DTCs set, except for DTC C05DD.
- If any other DTCs are set
  Diagnose other DTCs first.
- Go to next step: If no other DTCs are set
Operate the vehicle within the Conditions for Running the DTC.
Verify the following parameters are within 1.6 km/h (1 MPH) of each other:
- Electronic Brake Control Module - Left Front Wheel Speed Signal
- Electronic Brake Control Module - Right Front Wheel Speed Signal
- Electronic Brake Control Module - Left Rear Wheel Speed Signal
- Electronic Brake Control Module - Right Rear Wheel Speed Signal
- If not within 1.6 km/h (1 MPH) of each other
  Refer to: DTC C0500-C0504, C0506-C0510, or C0512-C0516
- Go to next step: If within 1.6 km/h (1 MPH) of each other
Perform the scan tool learn/reset function: Range Actuator Correlation Learn
Refer to: Transfer Case Range Actuator Correlation Learn
Verify DTC C05DD is not set.
- If the DTC sets
  Mechanical Condition - Transfer Case Clutch Pack Assembly
  
  Refer to: Transfer Case Disassemble
- Go to next step: If the DTC is not set
Operate the vehicle within the Conditions for Running the DTC.
Verify DTC C05DD is not set.
- If the DTC sets
  Mechanical Condition - Transfer Case Clutch Pack Assembly
  
  Refer to: Transfer Case Disassemble
- Go to next step: If the DTC is not set
All OK.