Transfer Case Front Case Half and Components
WARNING: This page is about a different variant/trim than selected.
Transfer Case Front Case Half and Components
| Callout | Component Name | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Transfer Case Nut [6x] | - | - | 58 N.m (43 lb ft) | Transfer Case Assemble |
| 2 | Transfer Case Stud [6x] | - | - | 58 N.m (43 lb ft) | Transfer Case Assemble |
| 3 | Transfer Case Input Shaft Inner Retaining Ring | Yes | - | - | Transfer Case Assemble |
| 4 | Transfer Case Front Output Shaft Seal | Yes | - | - | Transfer Case Assemble |
| 5 | Transfer Case Front Output Shaft Boot Clamp [2x] | Yes | - | - | Transfer Case Assemble |
| 6 | Transfer Case Front Output Shaft Boot | - | - | - | Transfer Case Assemble |
| 7 | Transfer Case Vent | Yes | Yes | - | Transfer Case Assemble |
| 8 | Transfer Case Adapter Gasket | Yes | - | - | Transfer Case Assemble |
| 9 | Transfer Case Input Shaft Bearing Outer Retaining Ring | Yes | - | - | Transfer Case Assemble |
| 10 | Transfer Case Input Shaft Seal | Yes | - | - | Transfer Case Assemble |