LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Transfer Case - Mp 3015 (NP0)) >> Repair Instructions - On Vehicle >> Transfer Case Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5584949Courtesy of GENERAL MOTORS COMPANY

    Transfer Case Control Module (1) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Transfer Case Control Module Bracket Nut (2) - Install and tighten [2x] - Fastener Specifications 
  3. GM5584898Courtesy of GENERAL MOTORS COMPANY

    Position and connect the body harness connector (2).

  4. Connect the transfer case control module electrical connector (1).
  5. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
  6. Perform the K69 transfer case control module programming and setup. K69 Transfer Case Control Module: Programming and Setup
scientia non olet · About LEMON Manuals