LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Transfer Case - Mp 3015 (NP0)) >> Repair Instructions - On Vehicle >> Transfer Case Assembly Replacement (LM2 without F47) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Place the transmission in neutral service mode. Neutral Service Mode
  2. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
  3. Front Wheelhouse Liner - Right Side - Remove - Front Wheelhouse Liner Replacement
  4. GM5340362Courtesy of GENERAL MOTORS COMPANY

    Exhaust Front Pipe Nut (1) - Remove [2x]

  5. GM5634664Courtesy of GENERAL MOTORS COMPANY

    Catalytic Converter Brace Bracket Nut (1) - Remove [2x]

  6. Wiring Harness Retainer (2) @ Catalytic Converter Brace Bracket (3) - Remove
  7. Catalytic Converter Brace Bracket (3) - Remove
  8. GM5149436Courtesy of GENERAL MOTORS COMPANY

    Using a suitable tool, remove the position 2 nitrogen oxides sensor (1) from the nitrogen oxides catalytic converter.

  9. GM5150652Courtesy of GENERAL MOTORS COMPANY

    Using a suitable tool, remove the position 3 nitrogen oxides sensor (1) from the nitrogen oxides catalytic converter.

  10. GM5151789Courtesy of GENERAL MOTORS COMPANY

    Using a suitable tool, remove the exhaust particulate matter sensor (1) from the nitrogen oxides catalytic converter.

  11. GM5341429Courtesy of GENERAL MOTORS COMPANY

    Exhaust Pipe Clamp (1) - Loosen

  12. GM5341378Courtesy of GENERAL MOTORS COMPANY

    Exhaust Front Pipe Nut (1) - Remove [2x]

  13. GM5184846Courtesy of GENERAL MOTORS COMPANY

    Nitrogen Oxides Catalytic Converter (1) - Remove

  14. Exhaust System Front Gasket (2) - Remove and DISCARD
  15. GM5586901Courtesy of GENERAL MOTORS COMPANY

    Drain the fluid from the transfer case. Transfer Case Fluid Replacement 

  16. GM5629505Courtesy of GENERAL MOTORS COMPANY

    Transfer Case Front Output Shaft Boot Clamp (1) @ Front Axle Propeller Shaft - Remove and DISCARD

  17. Reposition the transfer case front output shaft boot (2) and mark a reference point between the front axle propeller shaft and the transfer case front output shaft.
  18. GM5629570Courtesy of GENERAL MOTORS COMPANY

    Mark a reference point between the front axle propeller shaft (1) and the front differential drive pinion gear yoke.

  19. Front Axle Propeller Shaft Bolt (2) - Remove [6x]
  20. Front Axle Propeller Shaft Washer (3) - Remove [3x]
  21. GM5629637Courtesy of GENERAL MOTORS COMPANY

    Front Axle Propeller Shaft (1) - Remove

  22. GM5608481Courtesy of GENERAL MOTORS COMPANY

    Transfer Case Front Output Shaft Boot Clamp (2) @ Transfer Case - Remove and DISCARD

  23. Transfer Case Front Output Shaft Boot (1) - Remove
  24. GM5591283Courtesy of GENERAL MOTORS COMPANY

    Mark the relationship of the propeller shaft to the differential drive pinion gear yoke.

  25. Rear Propeller Shaft Bolt (1) - Remove [4x]
  26. GM5044196Courtesy of GENERAL MOTORS COMPANY

    Propeller Shaft (1) - Remove

  27. GM5155415Courtesy of GENERAL MOTORS COMPANY

    Fuel Heater Inlet and Outlet Bolt (1) @ Transmission Support Crossmember - Remove

  28. GM5674935Courtesy of GENERAL MOTORS COMPANY

    Remove the 4 wiring harness retainers (3), then reposition the wiring harness as necessary.

  29. GM4971868Courtesy of GENERAL MOTORS COMPANY

    Transmission Mount Nut (1) - Remove [2x]

  30. Support the transmission with a suitable jack.
  31. GM4971885Courtesy of GENERAL MOTORS COMPANY

    Transmission Support Crossmember Nut (1) - Remove [4x]

  32. Transmission Support Crossmember Bolt (2) - Remove [4x]
  33. GM4971889Courtesy of GENERAL MOTORS COMPANY

    Transmission Support Crossmember (1) - Remove

  34. GM5590452Courtesy of GENERAL MOTORS COMPANY

    Transmission Mount Bolt (1) - Remove [2x]

  35. Transmission Mount (2) - Remove
  36. GM5185017Courtesy of GENERAL MOTORS COMPANY

    Disconnect the wiring harness retainers.

  37. Catalytic Converter Brace Bracket Bolt (1) - Remove [2x]
  38. Exhaust Front Bracket (2) - Remove
  39. GM4960510Courtesy of GENERAL MOTORS COMPANY

    Transmission Heat Shield Bolt (2) - Remove

  40. Transmission Heat Shield Bolt (1) - Remove [2x]
  41. Transmission Heat Shield (3) - Remove
  42. GM5605434Courtesy of GENERAL MOTORS COMPANY

    Disconnect the transfer case two/four wheel drive actuator electrical connector (1).

  43. Disconnect the transfer case two/four wheel drive actuator position sensor electrical connector (2).
  44. Remove the wiring harness retainer (3) from the transfer case and position the wiring harness out of the way.
  45. GM5606248Courtesy of GENERAL MOTORS COMPANY

    Transfer Case Vent Hose (1) - Remove

  46. Using a suitable transmission jack, support the transfer case.
  47. Using suitable straps or chains, secure the transfer case to the transmission jack.
  48. GM5606810Courtesy of GENERAL MOTORS COMPANY

    Transfer Case Nut (1) - Remove [6x]

  49. Transfer Case (2) - Remove
  50. Transfer Case Adapter Gasket (3) - Remove and DISCARD
  51. Disconnect the wiring harness retainers.
scientia non olet · About LEMON Manuals