LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe PPV, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Transfer Case - Mp 3015 (NP0)) >> Repair Instructions - Off Vehicle >> Front Output Shaft Drive Sprocket Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
GM5060404Courtesy of GENERAL MOTORS COMPANY
  1. Transfer Case Front Output Shaft Drive Sprocket Bearing- Front (4)
    1. Install the bearing using the J-8092  Universal Driver (1) and DT-48211  bearing installer (2).
    2. Ensure the flat edge of the bearing is facing upward.
    3. Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
  2. Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear (3)
    1. Install the bearing using the J-8092  Universal Driver (1) and DT-48211  Drive Sprocket Bearing Installer (2).
    2. Ensure the flat edge of the bearing is facing upward.
    3. Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
scientia non olet · About LEMON Manuals