Conditions for Setting the DTC

C05DD 54 

Calibration/Software = Not Learned - 20 times.

C05DD 98 

Calculated Clutch Temperature = Greater than a predefined threshold

C05DD 67 

Condition 1

• Transfer Case Clutch Torque = Enabled
• Torque Error - 10 times
• For 10 consecutive events.

Condition 2

• Transfer Case Clutch Torque = Enabled
• Torque Error - 10 times
• Wheel Slip Status = Greater than a predefined threshold

C05DD F3 

Transfer Case Clutch = Worn

C05DD F4 

Condition 1

• Range Actuator Position Sensor = Maximum Travel Exceeded - 170 degrees
• The above condition(s) must occur 10 times.

Condition 2

• Transfer Case Range Position Sensor = Maximum Travel Exceeded - 170 degrees
• The above condition(s) must occur 10 times.