2WD Mode Power Flow
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Input Shaft |
| 2 | Transfer Case Scissor Mechanism Lever |
| 3 | Transfer Case Four Wheel Drive Clutch Pack |
| 4 | Transfer Case Front Output Shaft Drive Chain Assembly |
| 5 | Transfer Case Rear Output Shaft |
| 6 | Transfer Case Two/Four Wheel Drive Actuator Shaft Gear |
| 7 | Transfer Case Front Output Shaft |
| 8 | Transfer Case Two/Four Wheel Drive Actuator Cam |
When the MP 3015 ATC is in the 2WD mode, the power flows from the transmission (1) to the input shaft (2). The input shaft (2) is splined to the rear output shaft (3). The rear output shaft (3) delivers the power flow to the rear propshaft (4). The position of the control actuator shaft (6) allows no clutch (5) engagement.