Assembly and Component Identification
Check the transfer case assembly bar code label (1) to determine if the assembly contains first or second design components. Refer to: Magna Transfer Case Bar Code Label and the Production Assembly Breakpoints Table.
Separate the case halves. Refer to: Transfer Case Disassemble .
Remove the rear output shaft assembly (1) and the high/low clutch (2).
Inspect the rear face of the input shaft. (LD)
A light duty assembly with first design components can be identified by an input shaft with 2 oil drain holes (1) 180 degrees apart.
A light duty assembly with second design components can be identified by an input shaft with 3 oil drain holes 120 degrees apart.
Inspect the rear face of the input shaft. (HD)
A heavy duty assembly with first design components can be identified by an input shaft with 2 oil drain holes (1) 180 degrees apart.
A heavy duty assembly with second design components can be identified by an input shaft with 3 oil drain holes 120 degrees apart.
- Refer to: Appropriate Parts Identification Table.