Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify DTC P26C0, P26C2, P29FA, P29FB, U111A is not set.
- If DTC P26C0, P26C2, P29FA, P29FB, U111A is set
- Go to next step: If DTC P26C0, P26C2, P29FA, P29FB, U111A is not set
- Verify the coolant is at the correct level.
- Verify the following conditions do not exist: Q97B Engine Coolant Flow Control Valve - Block
- Leaking - Refer to: Loss of Coolant
- Missing components
- Stuck Closed
- Stuck Open
- Visible Damage
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.