Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Verify the condition does not exist: Reductant Level = Less than 20%
- If a condition exists
Repair as necessary
- Go to next step: If no condition exists
- If a condition exists
- Perform the following procedure/test: Contaminants-in-Diesel Exhaust Fluid Diagnosis .
- If a condition exists
Repair as necessary
- Go to next step: If no condition exists
- If a condition exists
- Ignition - On / Vehicle - In Service Mode
- Perform the scan tool function: Reductant System Leak Test
- Verify a condition does not exist with the component:
- Q61 Reductant Injector - Leaking
- Reductant Line - Leaking
- If a condition exists
Repair as necessary
- Go to next step: If no condition exists
- Perform the following procedure/test: Reductant Fluid Injector Quantity Test
- If the procedure/test does not pass
Replace the component that has failed in the test.
- Go to next step: If the procedure/test passes
- If the procedure/test does not pass
- Perform the scan tool function: Reductant System Leak Test
- Verify the scan tool parameter: Reductant Pressure = Greater than 450 kPa (65.3 PSI)
- If 450 kPa (65.3 PSI) or less
Replace the component: A38 Reductant Pump and Sensor Assembly
- Go to next step: If greater than 450 kPa (65.3 PSI)
- If 450 kPa (65.3 PSI) or less
- All OK.