Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On / Vehicle - In Service Mode
Verify there are no DTCs set related to the following component/system: Fuel System
- If a related DTC is set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If a related DTC is not set
Verify the following conditions do not exist:
- Aftermarket equipment/accessories: Performance Components - Installed
- Fuel - Contamination. Refer to: Fuel System Specifications , or Contaminants-in-Fuel Diagnosis
- If a condition exists
  Repair or replace as necessary
- Go to next step: If no condition exists
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
All OK.