Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P10F4 is not set.
- If the DTC is set
- Perform all necessary programming and setup procedures for the control module: K115 Reductant Control Module
- Verify the DTC does not set.
- If the DTC sets - Replace the component: K115 Reductant Control Module
- Go to next step: If the DTC does not set
- All OK.
- Go to next step: If the DTC is not set
- Verify DTC P20FF is not set.
- If the DTC is set
Replace the component: K115 Reductant Control Module
- Go to next step: If the DTC is not set
- If the DTC is set
- All OK.