Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle & All vehicle systems - Off
- Disconnect the electrical connector: Q74 Engine Coolant Bypass Valve
- Test for less than 10 ohms between the test points: Low Reference circuit terminal 5 & Ground
- If 10 ohms or greater
- Disconnect the appropriate electrical connector: K20 Engine Control Module
- Test for less than 2 ohms between the test points: Low Reference circuit terminal 5 @ Component harness & The other end of the circuit @ Control module harness
- If 2 ohms or greater - Repair the open/high resistance in the circuit.
- If less than 2 ohms - Replace the component: K20 Engine Control Module
- Go to next step: If less than 10 ohms
- Ignition - On / Vehicle - In Service Mode
- Test for 4.8 to 5.2 V between the test points: 5 V Reference circuit terminal 3 & Low Reference circuit terminal 5
- If less than 4.8 V
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: K20 Engine Control Module
- Test for infinite resistance between the test points: 5 V Reference circuit terminal 3 @ Component harness & Ground
- If less than infinite resistance - Repair the short to ground on the circuit.
- Go to next step: If infinite resistance
- Test for less than 2 ohms between the test points: 5 V Reference circuit terminal 3 @ Component harness & The other end of the circuit @ Control module harness
- If 2 ohms or greater - Repair the open/high resistance in the circuit.
- If less than 2 ohms - Replace the component: K20 Engine Control Module
- If greater than 5.2 V
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: K20 Engine Control Module
- Ignition - On / Vehicle - In Service Mode
- Test for less than 1 V between the test points: 5 V Reference circuit terminal 3 @ Component harness & Ground
- If 1 V or greater - Repair the short to voltage on the circuit.
- If less than 1 V - Replace the component: K20 Engine Control Module
- Go to next step: If between 4.8 and 5.2 V
- Test for 4 to 8 V between the test points: Signal circuit terminal 4 @ Component harness & Ground
- If greater than 8 V
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: K20 Engine Control Module
- Ignition - On / Vehicle - In Service Mode
- Test for less than 1 V between the test points: Signal circuit terminal 4 @ Component harness & Ground
- If 1 V or greater - Repair the short to voltage on the circuit.
- If less than 1 V - Replace the component: K20 Engine Control Module
- Go to next step: If less than 4 V
- Disconnect the appropriate electrical connector: K20 Engine Control Module
- Test for infinite resistance between the test points: Signal circuit terminal 4 @ Component harness & Ground
- If less than infinite resistance
Repair the short to ground on the circuit:
- Go to next step: If infinite resistance
- If less than infinite resistance
- Test for less than 2 ohms between the test points: Signal circuit terminal 4 @ Component harness & The other end of the circuit @ Control module harness
- If 2 ohms or greater
Repair the open/high resistance in the circuit:
- Go to next step: If less than 2 ohms
Go to next step: Replace the component: K20 Engine Control Module
- If 2 ohms or greater
- Go to next step: If between 4 and 8 V
- Test or replace the component: Q74 Engine Coolant Bypass Valve
NOTE:
It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.